Although the manufacture of solar panels is done in a strict quality controlled environment, for experimental purposes you can build your own solar panel to see how the sun’s energy can be converted to electricity. While the most efficient panels are made with silicon, you can build your own solar panel by using cuprous oxide, a material known to cause light to be turned into electricity. You probably cannot go into a store an buy cuprous oxide but you can duplicate it on a thin sheet of copper.
You’ll need about one square foot of thin copper plate, 2 alligator clips and short leads of wire, a wide mouth glass jar, tap water and salt. The utilization of a voltmeter, capable of measuring intensely tiny quantity of electricity will be wanted to see the final result. To build your own solar cell you’ll need an electrical stove or hot plate on which to heat the copper sheeting. Place the copper sheet on the burner and turn it on high and let it sit there for approximately 30 mins.
As it heats, you see the plate turn colours and the heat will show the outline of the heating coil underneath the plate. As it gets hotter it will begin to turn dark until the entire sheet has a black coating. After the entire sheet is black, turn off the burner and let it sit to cool for about 20 minutes. As it cools the black cuprous oxide coating will begin to pop off the sheet, leaving a thins coating of red on the copper. This red coating is needed to build your own solar panel, and while the majority of the black can be rinsed off under running water, it should not be brushed clean.
Using the alligator clips, connect the copper sheet to one the apex of one side of the glass jar. Attach another clean copper sheet to the opposite side of the jar. Mix about 2 big spoons of salt into hot tap water, ensuring it dissolves and then pour it into the jar. Be cautious the water doesn’t get on the alligator clips. The 2 copper sheets should be under water with roughly one in. left exposed at the pinnacle of the car to build your own solar cell.
Scrupulously place the whole contraption in the daylight, either in front of a window or carry it outside and reveal it to the sun. Using the voltmeter connect the leads to the 2 alligator and you can see the meter indicate the tiny quantity of power being generated by daylight, establishing you managed to build your own solar cell.
For news and information on how to build solar panels for power or any other information about renewable energy visit our website.
Recent Comments